ISO Fits Explained Simply
Wanneer dit van toepassing is
Use this guide when you need shared vocabulary between design, machining, and inspection without opening a full standards course.
Te gebruiken tool
Browser-based preliminary check for ISO Fit Tolerance Helper — fast estimates, not code or stamped design output.
ISO Fit Tolerance Helper openen →Stappen
- 1Choose hole-basis or shaft-basis preference consistent with your shop standards.
- 2Select a fit designation appropriate to motion vs permanence needs.
- 3Translate fit symbols into limit deviations for the chosen nominal.
- 4Verify manufacturing can hold the grades you specified.
- 5Document inspection criteria alongside functional intent.
Voorbeelden
- H7/g6-type discussions for sliding assemblies.
- Press-fit bearing seats requiring process-controlled interference.
Vermijd dit
- Specifying grades the shop cannot reliably measure.
- Confusing deviation sign conventions between shaft and hole.
- Skipping thermal and elastic deformation on critical press fits.
Gerelateerde tools
Op de blog
Meer in Techniek
- How to Calculate Pressure Drop in Pipes
- What Reynolds Number Means in Pipe Flow
- How Pump Affinity Laws Change Flow, Head, and Power
- How to Calculate Voltage Drop for Cable Runs
- Single-Phase vs Three-Phase Power Basics
- How to Estimate Dew Point
Alle taakhandleidingen of bekijk de volledige lijst op het Techniek-hub.
Veelgestelde vragen
Metric vs imperial fits?
Do not mix systems on the same drawing without explicit conversion notes.
Statistical tolerancing?
ISO fits assume traditional limit tolerancing unless you adopt statistical methods explicitly.